Xantech MRKP1E Uživatelský manuál

INSTALLATION INSTRUCTIONS MRKP1E Keypad controller EU and UK Standard

9 MRKP1E – REAR CONNECTORS Figure 2.3: Rear connector board of MRKP1E Keypad ITEM DESCRIPTION 1 Expansion RJ-45 Port 2 Controller RJ-45 Port

13 Internal IR Receiver The internal IR receiver is located beneath the center of the keypad’s face plate. The internal IR receiver receives IR comm

11 Note: Do not mount the MRKP1E in the same electrical back- box as high voltage devices such as electrical outlets or switches. Figure 2.5: MRK

1 Safety Information Read Information — All the safety and operating information should be read before the appliance is operated. Follow Informatio

21 2 Safety Check — Upon completion of any service or repairs to this audio product, ask the service technician to perform safety checks to determi

3 • Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. •

19 5. Troubleshooting Symptom Possible Cause Solution MRKP1E does not power up 1. RJ-45 plug crimped incorrectly; or wiring pin-out of

5 Defining Terms Zone A Zone is defined as an area of the house that has separate source selection capabilities from all other areas of the house. Ty

17 Fig. 4.1 Main Setup Menu Diagram (continued on next page) (MRC88m/MRAUDIO8X8m require Firmware Ver. 2.03 or later to work with the MRKP1E) co

7 Pre-Wiring CAT-5 Wiring between MRC88m and MRKP1E The MRC88m and all associated components are wired using CAT-5 terminated to the T568A or T568B

15 SETUP button X button 4. MRKP1E Main Setup Menu To access the Main Setup Menu, 1. Press and hold down the “X” key for at least 3 seconds. 2.